HEC1

$1,449.00

Return Policy

Specifications

HEC1 Specs @ 5 LPM:
MMW: 25.70
Voltage: 13.8 (default)
Amps: 14.1
Seconds: 60
Test volume: 5000ml (5L)
Total # of plates: 13
Active plate area: 16 sq inches
# of cell stacks: 2
Barometric pressure: 1016
Gas temperature: 120F
Voltage per cell: 2.30
Amps Per Cell: 7.05
Current density: 0.44 per inch2
Energy used: 194.58 watts
Resistance: 0.98 ohms
Current efficiency: 480.84%
Voltage efficiency: 64.35%
Total efficiency: 272.59%

This data was collected using 1liter of 12% electrolyte (Potassium Hydroxide).

The HEC1 is a true calibrated HHO generator providing the exact amount of HHO required for each application.

FAQ

Q: What is HHO - hydrogen on demand?

A: HHO uses a process known as electrolysis to run an electric current through water and break apart its molecules. Hydrogen and oxygen bubble up from the water and are fed into the engine producing more efficient fuel combustion

Q: Doesn't this violate the law of thermodynamics

A: Supplemental HHO is not subject to the law of thermodynamics. The law applies to a closed loop system, i.e., one in which one source of energy produces another that is then consumed. The HHO system is two systems; one produces the gas; the other is the process in which atoms of hydrogen adhere to molecules of gasoline and its additives and burn them more quickly and more completely, increasing engine efficiency far more than the net "energy cost" needed to create it.

Q: What makes the HEC1 better than other Hydrogen on Demand systems?

A: The heart of the HEC1 is an advanced 13 plate hydrogen electrolyzer featuring Goodyear rubber gaskets. Each 316L stainless steel plate is Ultrasonically cleaned, surface enhanced, pacified and assembled by skilled craftsmen.

DIGITAL ELECTROLYSIS CONTROLLER: The 150 amp controller generates a perfect, digitally-produced square wave, with no distortion, at full load using MOSFET controller chips. Our transistors feature incredibly fast rise and fall times, producing a clean, digital signal. This results in more efficient hydrogen production, and less heat generation making the electronics more reliable for longer life in real-world environments. You can see the Digital Electrolysis Controller being tuned for maximum output below:

The HEC1 is temperature controlled as a safety feature to prevent any chance of overheating or thermal run-away.

The electrolyte reservoir / flash-back protector is made of high temperature plastic and mounted with the electrolyzer and controller in a vented ABS plastic case.

The HEC1

Alternative Energy Discount House. Is a distributor of the HEC1 commercial "plug and play" hydrogen on demand system.

The HEC1 is the highest quality commercial hydrogen on demand system available. Designed from the ground up for safe and robust hydrogen generation for heavy equipment, over the road, and marine applications.

Each HEC1 is tested and preconditioned at the factory to provide high output, low maintenance, and long life.

The average cost savings using supplemental hydrogen run between 20% and 60% depending on application.

The HEC1 is design to be mounted externally for safety, is automated (no operator intervention), and has an output of up to 5 LPM.

You can see the HEC1 in operation below: